1 — dcesetup Reference Page

[Previous] [Next] [Contents]

This chapter contains the dcesetup(8dce) reference page. Gradient DCE for Tru64 UNIX provides the dcesetup utility for use in configuring DCE services. The dcesetup utility replaces the dce_config program provided with OSF DCE Release 1.1.

Description

dcesetup - Configures and starts up DCE. The command invokes an enhanced configuration utility to configure and start DCE services. The configuration utility displays a menu that allows you to perform the following operations:

• Configure DCE services (config)

• Show DCE configuration and active daemons (show)

• Terminate all active DCE daemons (stop)

• Start all DCE daemons (start)

• Terminate and restart all DCE daemons (restart)

• Terminate all active DCE daemons and remove all temporary local DCE databases (clean)

• Terminate all active DCE daemons and remove all permanent local DCE databases (clobber)

• Run the Configuration Verification Program (cvp)

You must have root authority to run the dcesetup command. See the Gradient DCE for Tru64 UNIX Installation and Configuration Guide and the Gradient DCE for Tru64 UNIX Product Guide for more information about dcesetup.

[Previous] [Next] [Contents]

To make comments or ask for help, contact support@entegrity.com.

Copyright © 2001 Entegrity Solutions Corporation & its subsidiaries.

Copyright © 1998-2001 Compaq Computer Corporation.

All rights reserved.